How Does The Descaler Work?
The Descaler causes the microscopic compounds in the form of scale to be released back into the flow of water and therefore revert back to their original compounds when re-entering the water flow. Treated water does not change or alter any of the natural mineral content of water so essential for life. No salt or chemicals are added to your water system.
Fitting Instructions
The great thing about our Ecocamel descaler is that it is very user-friendly and fits in under 15 seconds. There are no pipes to cut, no electrical mains supply required, no corrosive salts are added to the water system and there are no running costs or maintenance required.
Where to fit my Ecocamel Descaler?
Well, the best place would be on the rising water main, after the stopcock, where water enters the home (often under the kitchen sink), before any branches or joints. If water is stored in a water tank for more than 24 hours then a second Ecocamel Descaler should be fitted on the exit pipe of the storage tank. If you have a boiler then a further unit could be fitted to the inlet pipe of the boiler as this will ensure the best possible result. The Descaler will fit a standard 15mm pipe. It will work on a copper or plastic pipework but should not be used on lead pipes.
How do I fit my Ecocamel Descaler?
Avoid pinching your fingers between the two parts by sliding the sections apart rather than pulling them apart. When fitting them to the pipe avoid catching your fingers by sliding the two parts together.
If you have any questions please call us on: 0208 211 3666 or
email customerservices@ecocamel.com